CLICK HERE FOR FULL PRODUCT LINE
OVERVIEW:The AFR Plus or GEN 4 by Dobeck Performance brings together two technologies within one system to make it the most powerful, user-friendly tuning device on the market. AFR Plus combines an EFI controller with a wideband O2 sensor and AFR gauge to provide a user instant fuel trimming ability and feedback about their vehicle’s tuning operation.
GEN 4 is the short term used to describe the Generation 4 Electronic Fuel Injection (EFI) controller and Air Fuel Ratio (AFR) Gauge Kit manufactured by Dobeck Performance. The GEN 4 is a piggy-back EFI controller because it does not replace the stock ECU, but rather monitors the signals to the injectors and makes fuel adjustments based on the mode settings. The GEN 4 has a push button interface on the gauge allowing access up to 6 different modes to allow for quick fine tuning by the end user without needing a computer.
KEY FEATURES:
- AFR PLUS / GEN 4 FEATURES
- FULLY COMPPATIBLE WITH ALL AFTERMARKET EFI CONTROLLERS INCLUDING REPLACEMENT ECUs.
- HAS CAPABILITY OF BEING YOUR ONLY FUEL MAPPING SOLUTION AS WELL
- IDEAL FOR MAXIMIZING FUEL ECONOMY FOR TRIKES, SIDECARS, PULLING TRAILERS, OR FIGHTING A HEAD WIND
- AFR GAUGE FEATURES
- AFR GAUGE READING FROM 10 TO 16 TO PROVIDE INSTANT AFR FEEDBACK READINGS
- STANDARD 2-1/16" ROUND GAUGE
- WATER RESISTANT
- PUSH BUTTON INTERFACE TO ALLOW QUICK FINE TUNING AT YOUR FINGERTIPS
- EASY TO SEE LED LIGHTS TO INDICATE OPERATING ZONE ON THE GAUGE
- USES BOSCH WIDEBAND O2 SENSOR WITH BOSCH CHIP POWERED WIDEBAND CONTROLLER
- SELF-ADJUSTING BACK LIGHTING DISPLAY FOR NIGHT VIEWING
- EFI CONTROLLER FEATURES
- USES LOAD BASED TECHNOLOGY WHICH ALLOWS FOR TUNING IN EVERY GEAR
- 3 MAIN ZONES OF OPERATION TO TARGET DESIRED AFR
- ABILITY TO ADD OR PULL FUEL WITHOUT ALTERING THE STOCK FUEL MAP
- CLOSED LOOP OPERATION OFF OF WIDEBAND O2 SENSOR INPUT
- PLUG N PLAY INSTALLATION - NO WIRE SPLICING
- NARROWBAND GENERATION FOR STOCK O2 SIGNAL
- COMPUTER REPROGRAMMABEL BY IRDA TECHNOLOGY IF NEEDED
The information our gauge displays is all you need to get the most out of your existing fuel controller or mapping software. With a retail cost of $325 it has saved some of our customers that much money in ONLY 3500 miles.
GENERAL TERMINOLOGY EXPLANATIONS:
Air Fuel Ratio (AFR) - The most common reference term used for mixtures in internal combustion engines. It is the ratio between the mass of air and the mass of fuel in the fuel-air mix at any given moment.
Oxygen (O2) sensor - Is an electronic device that measures the proportion of oxygen (O2) in the exhaust gas.
Wideband vs Narrowband sensors - A narrowband O2 sensor is only calibrated to know whether the current AFR is rich, lean, or stoic. A wideband O2 sensor is much more sophisticated and can supply the exact AFR measurement across a wide range of possible AFR values.
Load - Is the measurement of how hard an engine is working. Coasting downhill is considered very low load. Driving uphill is considered high load.
Open loop vs Closed loop - Different operations both the stock ECU and the GEN 4 can function under independently. Open loop means NO fuel trimming is occurring based on the O2 sensor signal. Closed loop is using the O2 sensor input signal to react rapidly to the changing conditions and make fuel trims to match the desired air/fuel mixture.